Zinsser AllCoat (Solvent-Based)

About this product:

Ready to use – no dilution necessary. In most cases only one coat is needed. Porous surfaces may require two coats to properly seal. Prime entire surface for best results

Technical Information

Touch Dry

1 hour

Recoatable

2 hours

Coverage

9m² per litre

Finish

Flat

Key Benefits

  • Solvent based stain blocking performance without odour
  • Seals difficult stains form water, fire, smoke and nicotine
  • Adheres to glossy surfaces without pre-sanding or deglossing
  • Bright white, non-yellowing, dead-flat finish
  • Easy-sand formula

Product Information

  • Sizes

    10lt, 5lt

Application Method

Shake or stir well before using. Apply with synthetic bristle brush, roller or sprayer. For airless spraying, use a .017” tip and high-medium (2000-2500 PSI) pressure. Ensure air and surface temperature are between 10° & 32°C and humidity is less than 85% during application and cure of the product. Avoid painting in direct sunlight and maintain a “wet edge” to avoid lapping. Ensure conditions during application and cure are favourable, do not apply if there is a likelihood of rain, frost, fog or condensation affecting the freshly applied paint before it has fully cured